The Proper And Quality Installation Of Satellite Dishes

How to properly and quickly set up a satellite dish without the help of a professional to install a satellite dish. 1.Nuzhno choose where to install, that is exactly where we will perform the installation of satellite dishes. Requires public review from the point of installing a satellite, make sure that the trees keep healthbars from closing review or other surrendered, all satellites are located towards the south-west to south-east. And most are located high above the horizon satellites, located right in the south. Interfere with signal reception, any obstacles (houses, trees, power lines) on the line connecting the antenna and the satellite. In addition, the antenna must be in an easily accessible place for you, especially important at the time of its setting, and the reach of others, so it was impossible to easily bring it down.

2. Installing the bracket. Install the bracket preferably wedging metal bolts or screws, for concrete and masonry (silicate) walls, a wall with red or porous bricks to use bolts with plastic fillings. Around the attachment should always try to keep most of the brick and install mounting above the fourth row from the top, or at a distance of at least four bricks on the angle of the wall to avoid the appearance of cracks in the crease. In what is marking and drilling holes in the wall. Thereafter is driving and broaching of anchor bolts in the wall with the bracket and the tightening them further to go. Next, check the strength of the resulting design.

3. Assembling the dish. When assembling the necessary handled carefully and with mirror antenna, not to cause any mechanical damage, which changes the geometry of the mirror. After assembly, check all the strength tightening fasteners, check the correct assembly and is often collected properly and then set davolno tyazhnlo all UTB case. Before installing the antenna you need to install two additional mount Lenses (multifeed option for a three satellite) as shown in the figure. Left Amos, in the heart of Sirius and then Hot Bird. If you look at the mirror antenna is located on the converter imaginary line at a certain angle, and Hot Bird at the bottom and top of Amos. To connect the cable to use so-called F-connectors are placed on the cable without soldering. This is done correctly, as shown in photo: Trimmed 1.2 cm top layer of PVC on the edge of the cable. Shielded braid with foil tucked in the opposite direction. The internal filler is cut so that the remaining approximately 3 mm. F-connector on the cable is wound tight as long as the inner filling is out of the bottom connector. Central vein bite so that it protruded 2-3 mm beyond the edge connector. At the end of installation it is necessary to link all together. And we must remember that if you do not do everything yourself, then nobody on the ball you will not be set. A satellite dish installation today is worth more than a hundred dollars, and it without the cost of the equipment.